Simple codes, a very simple design, here is the meteorolgy station. It was from three years ago when I first started my club named MakerClub. Since it was my first year of teaching, it is that simple. Both because people were new to making these kind of things, and I was new to teaching, so Read more about Meteorology Station V1[…]
It was an ordinary day. I printed the first prototype using MakerBot. Then, the final protoype using Form 2. I cleaned the parts in IPA, cured under UV light. I was about to sand it, I realized that I accidentally printed two left sides. Ever since I 3D printed the right side of the filament Read more about Filament Holder V3[…]
It was a tire I 3D printed using Formlabs Form 2. I then needed to print the flexible part of the tire from MakerBot 5th gen replicator using NinjeFlex because it elongates more, making the flexible part to be easier to assemble. After everything was seemingly perfect, it taught me how fragile resin is, along Read more about Tire Prototype From SLA[…]
To make the hinge of it, I put nails into the deep freezer. When the nails shrinked in size because of the cold, I took them out of the deep freezer. I inserted them into the hinge. When they reached the room temperature, they became harder to remove, which is what I wanted. I Read more about Coffee Capsule Holder V2[…]
I was planning to take the measurements of my desk’s available height for a new monitor, but I couldn’t find the tape meter. I used hand span to measure. I then bought this monitor, hoping that it will fit. It didn’t fit because it was 1cm higher than it should be. I was ready for Read more about Monitor Stand[…]
Imagine you have a heavy dish of meal in your hand which you want to put it into the refrigerator. Because the meal is heavy, you cannot hold it in one hand. You want to open the refrigerator’s door while holding the dish. Imagine yourself jumping on one leg and putting the dish on the Read more about Fridge Door Pedal: Keee (From 3D Printing Competition 2016)[…]
On valentine’s day, I was helping a friend to make a gift to his girlfriend. He asked me to help him 3D print a ghost emoji necklace. The ghost emoji is on @Thingiverse, by RubyBot, but I added a hoop to it. Then, 3D printed on @Formlabs Form 2. He painted it. I hope they won’t break up, Read more about 3D Printed Ghost Emoji Necklace Help to a Friend[…]
I found more prototypes after I have taken this photo. But, guess which ugly phone case I am using… I 3D designed it using @SolidWorks. I 3d printed them using @makerbot and @Formlabs .
My dog and his long ears eat the food together sometimes, or sometimes we need to put a cone in his head for him not to bite himself, which makes him look like a walking satellite antenna. Becoming an antenna is hard for him because it interferes between the food and the food transceiver, his Read more about Dog Food Container Needs an Angle[…]
This was the first PCB board I made, from about 1.5 years ago using Altium. It is a light sensitive light. Darker it gets, brighter it will be. Notice the wording, don’t let it confuse the LDR(light dependent resistor) too, so make LDR and LED face opposite sides if you don’t want to create an Read more about 1.5 Years Ago: My First PCB[…]