Monitor Stand

I was planning to take the measurements of my desk’s available height for a new monitor, but I couldn’t find the tape meter. I used hand span to measure. I then bought this monitor, hoping that it will fit. It didn’t fit because it was 1cm higher than it should be. I was ready for that. I 3D printed a new holder for the monitor. I am glad that I couldn’t find the tape meter because I couldn’t get a monitor like this.

 

I 3D designed it using @SolidWorks. I 3d printed it using @Formlabs Form 2.

Leave a Reply

Your email address will not be published. Required fields are marked *